Firmware 3.925 FINAL released

[bovist]

Firmware 3.925 is now final, available in Github LATEST folder. If you experienced update problems with BETA firmware, you may have a board with faulty bootloader settings. Must be sent in for free update/repair.

Fatar ScanCore had a small bug that issued MIDI key velocity of 1 when key contacts where not closing properly, so played notes were "missing" or barely audible sometimes. This has been fixed with FATAR ScanCore #25. Key velocity curve has been altered to resemble a non-linear velocity=1/time behaviour. Should yield better results with piano modules etc. connected to HX3 organ.

I prepared an special update package available on https://github.com/keyboardpartner/HX3/ ... p?raw=true which only updates the FATAR ScanCore, nothing else. It is compatible with all firmwares and mk2 to mk3 boards. Tolerances in FATAR contacts seem to be huge from batch to batch, so I plan on adjustable velocity curves. However, new FATAR ScanCore works fine in most MIDI setups.

06/27/2016 FATAR ScanCore #25, MIDI ScanCore #30

- Added separate update package for FATAR/MIDI, will update ScanCore only
- Changed MIDI velocity scaling to triple squared curve in FATAR ScanCore
- "Missing notes" bug in FATAR ScanCore fixed
- New MIDI ScanCore #30 with 88 key support, full transpose 24 notes, upper manual split +1 and +2 octaves on lower part

05/05/2016 Firmware #3.925, HX3 Flash #3.9e

- HX3 Remote Dropdown menu bug on Win XP fixed
- XB2 Kit Transpose with PERCUSSION buttons (SECOND = DOWN, THIRD = UP) when Edit Mode ON
- Easier Common Preset combination select, blinking LEDs when saved
- Updated HX3 Remote and HX3 Flash
- New MIDI and FATAR ScanCores (see above)
- New "AUX Pot" Routing (was TONE pot analog input enable), TONE pot input may be routed to MASTER VOLUME or TONE function by HX3 Remote Parameter 492

Firmware Downloads:

https://github.com/keyboardpartner/HX3/ ... ter/LATEST