Keyboardpartner-Forum

Hi,

I have to connect the extension board and some other things, people on the forum have been very helpfull, and I did get some information from the wiki-pages, but I must be missing on some basic info pages somewhere, because the info needed simply for connecting the ext. board to main board for example, I cannot find, and I rather not have to ask step by step on this forum, so if anyone knows where to get schemes, guides/ manuals and install instructions for general hoax items, thanks for sending the links or pdf's. That would be a real help.

Thank you,

Alain

P.S. I do understand some german if required.

I find "The extension board connects to HX3 by 26-pin header PL33 and flat ribbon cable. "... question is "whereto?"..

Hi,
All informations You´ll find on our Wiki site
http://wiki.keyboardpartner.de/index.ph ... Hauptseite
just download the github zip

Thanks again happyfreddy,

I just found out about the PL3 missing connector for expansion board on the main board, will have to solder one myself.

best regards,

Alain

Hi ,
You can do this but regard the polarity of plug ( marked with Pin 1 with a square on board )
On plug itself there is a "triangle" above Pin 1 ( left besides the " spare nose" )
Solder first one pin in middle area than solder and press tight the plug parallel to board . When correct position solder the rest of pins
carefilly.
The connection flat cable is short and the polarity is 1: 1 . That means that the " nose" of both plugs shows in same direction. The red wire of flat cable on that side where the pin 1 is , so it looks "professional" .
Good luck

Thanks happyfreddy !!!

While you are on line,

Carsten wrote me that it was possible to set preset 1 to drawbarset B in remote, I have been looking like mad but cannot find the setting?

thank you,

Alain


GOT IT ;

" it is 483,"2nd DBs preset number" on organ defaults page. "

Thanks