Keyboardpartner-Forum

Hi Ramon,

I also had this vib issue on changing to #3841, though not the audio or rev. Setting C3 as organ default in the Editor and saving this didn't help. For the moment, because of a problem with my USB interface on the HX3, I can't check this again - I'm on FW#383/FPGA05072015 currently and I have to say I prefer the sound/chor-vib of this setup through my gear (v#383 also has the new taper files which are a big improvement). When I get a new interface I'm going to have another look at v3841.

Maybe some others had the same vib reset issue? It wasn't a big deal on my XK-3 setup as one twist of the knob put it back on C3 until the next restart. Still, it didn't happen on the older FW.

Paul

Have no Expander near me to recheck, but also faced some troubles while saving Chorus and Percussion values on 3.841.

Sorry: My fault, no problems any longer. Problem was probably due to the Voce Drawbar unit itself. During test I unpowered the expander but not the Voce. When testing today the activation of V/C is fine! So please ignore the following description:

Mine problem after upgrading the expander to 3.841

Using Voce Drawbar to control the expander it is no longer possible to activate the V/C. When using the Voce V/C selector I see the display scrolls between C1, V1, C2 etc. But problem is that the expander does only respond to pushing the V/C on/off button by showing V/C off. Shortly said, it is not possible to activate the V/C from the Voce any longer. This worked in previous firmware.

I had the same issue with C/V settings not saving in 3,84. I love the sound of the new C/V, but am waiting for bugs and tapering files to be worked out before upgrading from 3,83.

I've finally been able to reinstall FW#3841/FPGA16102015 and the C/V is definitely reverting to V1 on restart. Reverb, Audio Out selection and everything else is remembered ok so it's not a big deal, though I'm sure this can be fixed in a future update.

Paul

The Vibknob issue was solved with firmware 3.842. The bug did not appear on Expander modules.