Keyboardpartner-Forum

In the design process of a DIY build with two Fatar TP-8O manuals.

Based on what I've read, Fatarscan1 has replaced Fatarscan2 scanner cards for connecting Fatar manuals. Check.

However, when configuring this in HX3 manager, the documentation notes that scanfatr.dat must be used for fatarScan 1. Will this same file also work with Fatarscan2?

I can see in the wiki that this file is required:

"Once the board has been connected, install the scan driver scanft61.dat via the HX3 Manager"

However, that file is not listed in the HX3 manager boot load update utility. Is there a different name that it goes by or if not, where can that file be located?

https://wiki.keyboardpartner.de/index.p ... can_Boards

Please contact Keyboardpartner direct for required Scan Routine for Fatar scan 2
happyfreddy