Keyboardpartner-Forum

I'm using a Fatar 61TP/8O and the MIDI-Out velocity is still a little bit "hard", but much better than before! I have to select on my expander a velocity curve, which makes the hard output a little bit softer.

I have an additional question: upper and lower manual are sending notes on MIDI channels 1 and 2. But my bass pedal (which is connected via MIDI-In to my MK2 board) is sending nothing :-(
I would have expected that the pedal should also send something.

@Carsten: could you check that please ?a

A general question to the split function: it seems that the split function only works with the HX3 sound. Is it planned that this info is also transmitted to MIDI-Out ?

Thanks a lot!

Clemens

That´s correct !
MK2 board only sends keydata from direct coupled keyboards no one connected via MIDI IN like the pedal keys in this case.
If You want this too You must double the MIDI OUT from pedal and route this signal to a merger with MIDI OUT from HX 3 MK2 on second Input
of merger. Ie INput 1 of merger Channel 1 & 2 from HX 3 ; INPUT 2 Channel 3 from pedal = MIDI OUT MERGER Channel 1, 2, 3.

THe new MK 4 board with extensions board has an integrated merger and sends also direct Keydata and MIDI IN

Hallo,

die neue FatarScan 25 ist schon ein guter Schritt nach vorne! Mit meiner alten d3m ist die Kennlinie noch nicht optimal, hier könnte die e-Funktion noch etwas ausgeprägter sein. Allerdings lösen diverse Knöpfe der Percussion ein Sustain und der Rotor slow/fast eine Modulation aus.

Balou